Compuestos elásticos no lineales con condiciones de contacto imperfectas
DOI:
https://doi.org/10.21640/ns.v1i1.242Keywords:
Asymptotic Homogenization, Imperfect Contact, Effective Law, Non-Linear ElasticAbstract
In this contribution, the effective strongly non-linear elastic law is obtained, by means of the Asymptotic Homogenization Method (AHM), for a two-layer laminate composite (Al/Steel) with imperfect contact condition (spring and membrane type). In both cases the constituents exhibit isotropic properties. This work is an extension of the results before reported, where only perfect contacts for elastic or piezoelectric composites were considered. Some numerical examples demonstrate that the present model by AHM is efficient for the analysis of composites with presence of imperfect interphase.Downloads
References
Y. Benveniste, The effective mechanical behavior of a composite with imperfect contact be-tween the constituents. Mech. Mater., vol. 4, pp. 197-208, 1985.
Y. Benveniste and T. Miloh, Imperfect soft and stiff interfaces in two dimensional elasticity. Mech. Mater., vol. 33, pp. 309-323, 2001.
B. E. Pobedria, Mechanics of Composite Materials. Moscow University Press, Moscow. (in Russian) 1984.
J. J. Skrzypek, Plasticity and creep. Theory, examples and problems. Begel House, USA 1993.
Y. Hiki and A. V. Granato, Anharmonicity in noble metals; higher order elastic constants. Phys. Rev., vol. 144(2), pp. 411–419, 1966.
H. Czichos, (Editor), HUETTE - Grundlagen der Ingenieurwissenschaften, Springer, Berlin, pp. D45-D50, 2000.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2015 Nova Scientia
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Conditions for the freedom of publication: the journal, due to its scientific nature, must not have political or institutional undertones to groups that are foreign to the original objective of the same, or its mission, so that there is no censorship derived from the rigorous ruling process.
Due to this, the contents of the articles will be the responsibility of the authors, and once published, the considerations made to the same will be sent to the authors so that they resolve any possible controversies regarding their work.
The complete or partial reproduction of the work is authorized as long as the source is cited.
